Scope turret advice

[rex]

Put a new scope on a ultra mmc
The problem I have is, it’s ran out of left clicks?
About 2”?? ( shooting 2” to the right)
Any advice appreciated
Thanks

[AdeC]

Try reversing the mounts

[Mr. Gen]

bend the barrel in the opposite direction

[angrybear]

Either the barrel is bent, the scope is shagged, or there's a problem with the mounts.

Make sure the mounts are a matched pair
If the mounts are single strap (one bolt) with a separate clamp, make sure both clamps are the same side & same way up, very easy for one to rotate.
Make sure both mount bases are properly seated.

If it's a mountmaster type dirt cheap scope with mounts included, frankly take it back & save for a better model & buy good mounts to go with it.

[rex]

Either the barrel is bent, the scope is shagged, or there's a problem with the mounts.

Make sure the mounts are a matched pair
If the mounts are single strap (one bolt) with a separate clamp, make sure both clamps are the same side & same way up, very easy for one to rotate.
Make sure both mount bases are properly seated.

If it's a mountmaster type dirt cheap scope with mounts included, frankly take it back & save for a better model & buy good mounts to go with it.

Lols … it is a mountmaster scope
I have changed the mounts and all is fine now?
Thanks

[Gary C]

Either the barrel is bent, the scope is shagged, or there's a problem with the mounts.

Make sure the mounts are a matched pair
If the mounts are single strap (one bolt) with a separate clamp, make sure both clamps are the same side & same way up, very easy for one to rotate.
Make sure both mount bases are properly seated.

If it's a mountmaster type dirt cheap scope with mounts included, frankly take it back & save for a better model & buy good mounts to go with it.

It is never the scope in that situation. Too far out.