Kral NP02 Customisation

[Neil54]

Once the bottle is removed, you can regulate the rifle.
If the np03 stock is a straight swap then all would good.
If you need lots of different brackets, then may not be cost effective.
Regulators for the kral usually fit in the cylinder as the firing valve is in the cylinder "bung."

[gibsonk]

Thank you again for your advice, I am beginning to wonder if its better to let it go. Its going to be at least £150 to mod it. A replacement user rifle that fits is likely a lot less if I sell the NP02.

Will teach me with that knee jerk decision, real shame it's not the NP03

[32:1]

Why not simply swap out the rear bottle for a smaller carbon item, that sorts out pull length and weight

Not sure trigger is in same place for npo3 stock ?

Chris

[gibsonk]

Why not simply swap out the rear bottle for a smaller carbon item, that sorts out pull length and weight

Not sure trigger is in same place for npo3 stock ?

Chris

Interesting, I will look into that, it will help the weight as well.

I am taking a punt on it being the same, the NP02 is based off the 1 as i understand, the Webley Eclipse is the same as the NP02 but I cannot find any stock available for them.

I will check out carbon bottles, thanks for the pointer

[32:1]

Im sure the blocks look similar but trigger arranging for Krals range puts various options into block machining and trigger sets, cocking may be okay on other side but some sears won’t/ don’t fit and pressure gauges often fitted in wrong place and foul.

Id fit a smaller carbon bottle as its simple and effective, or just get the npo3 if thats what you want. The npo2 front cylinder is small and you will only get 25 shots max Id guess, the npo3 delivers around 40 in .177.


Ali express is cheap for carbon bottles of all sizes

[32:1]

Im sure the thread is m18 but check that out

Ive used these on other projects

https://m.aliexpress.com/item/100500...2-76207099897e

[mdunn]

Anyone know what thread and size, of the hammer adjuster that screws into back of block is thanks. Atb mick

[gibsonk]

Im sure the thread is m18 but check that out

Ive used these on other projects

https://m.aliexpress.com/item/100500...2-76207099897e

I had a quick look earlier at Ali, but need to measure up the bottle diameter and length to find a suitable one, thank you for the link I was confused with the plethora of bottles on there.

Should these be hydrotested before fitting, do we trust them out of the box, 200bar is a lot of pop if it goes