Will the place that fill it do a quick service?
Hi everyone,
Hope someone can help me with where I can get them please.
The o rings on the push button bleed valve of the diver bottle charging kit perished and leaking through.
I can see that they are made out of polyurethane material and I measured to be around 6.4 od, 3.6 id, 1.7cs
Thank you all in advance.
Will the place that fill it do a quick service?
HW 77K .22,Gammo Hornet .22 BSA 3-9 x 50 Night light ,HW 40 .177,Gamo Maxxim Elite .22 multi shot, Beeman P17 .177 red dot sight ,SMK CP2 co2 with Hawk 3-9 x 50.Slingshots PPMG+TTF PPMG mk 2 ott PPMG ott Original custom made solid Bronze, Number 15 of 20
Try Best Fittings.
Airgun Charging Equipment – Best Fittings
Bob
Thanks everyone for helping 👍
your measurements don't add up but taking into account how awkward small o ring id's can be to measure i'd gustimate the o ring you req is a bs006 in pu90
i do keep that size if you can't get it sorted locally
If it's an MDE valve contact MDE & ask, they might send you a couple.
I wouldn't be surprised if they were special to type seals rather than a simple O ring.
Last edited by angrybear; 07-03-2023 at 02:42 PM.
There is a Dive shop on Chells ind estate Stevenage there was one at Pin Green don't know if the same people, the one at Pin green did retest etc while you waited.