Qb78 22 barrel screw cut for moderator

[Davebean]

Any idea what this barrel is worth
https://ibb.co/8BTt1ws
https://ibb.co/6rg3sqb
https://ibb.co/B2dHsdJ
https://ibb.co/fq0Gdwy

[Neil54]

Only £45 new.
.22 not exactly sought after.

[mattyw1987]

I would say no much, the threading looks like it wasn't done correctly, look at where the threads meet the barrel should be recessed slightly and a nice square shoulder for the mod to sit against.

[Shed tuner]

I would say no much, the threading looks like it wasn't done correctly, look at where the threads meet the barrel should be recessed slightly and a nice square shoulder for the mod to sit against.

I was wondering about that... unless it was done in reverse, cutting from behind, I'd say it wasn't done on a lathe..

[mattyw1987]

I was wondering about that... unless it was done in reverse, cutting from behind, I'd say it wasn't done on a lathe..

Yes I'm not sure how it was done but I agree.

[--ped--]

looks to be turned down on a lathe but not single point formed and possibly a tailstock die holder or just a diestock
it maybe concentric to the bore it may not but without the shoulder cut and shoulder for the silencer to rest against i doubt it'll be aligned well

[u.k.neil]

Just put a thread protector over the mess that someone has made.


Neil

[Davebean]

A moderator screws into it no problem

[u.k.neil]

A moderator screws into it no problem

I will put money on that it will clip.


Neil

[Davebean]

Doesn't clip mate tried it
I am sure you don't need one either