Correct size spanner to use on a Hornady 'Sure Loc' Lock ring?

[CROWMAN]

A good quality adjustable wrench ?
Not the coarse / sloppy adjustable type

Rich

Thanks again as always for all replies, all varied, all good.

It is only a very light 'nip' to tighten the die just a bit, so until I can either get a spanner printed which would be ideal, or pick up one at a boot sale etc, I'm using a very large 'King Dick' adjustable wrench, far to big, but the wrench is well made and not a sloppy adjustment, a bit of a over kill, but I'm not paying £20-00 plus for a correct spanner

[neil82]

done some checking and a spanner for gas regulators will fit, about a fiver on the bay of e

[foxshooter]

Don’t do them up so tight you need a spanner is my advice!

I’ve a big bag of imperial spanner’s here from my late fathers garage, I’ll have a look and see what’s in there

Mark

[CROWMAN]

That's what I've done, located in my tool chest at last a good adjustable, job done.
Thanks for all replies.

[acmsarh]

See if you can find a box spanner that will fit over the die completely and it will engage all 6 face's of the nut.

[CROWMAN]

Thanks, but there are only 2 faces on these rings, but with the wrench I found and it is only a 'nip', job done now.

Thanks for all replies as always.