Results 1 to 4 of 4

Thread: Webley (mainly ) and trigger pulls.

  1. #1
    ggggr's Avatar
    ggggr is offline part time super hero and seeker of justice
    Join Date
    May 2008
    Location
    Flintshire Ch6 sort of near bagillt
    Posts
    2,384

    Webley (mainly ) and trigger pulls.

    While I am waiting patiently, hoping a Typhoon frame and any rough Webley projects might turn up, I have been having a small tinker with stuff.
    I recently bought a Webley Hurricane ---that was a little rough but mostly ok. After having a plink I decided to strip and lubricate it as it did seem a little dry.
    The piston was her was a little tight so that was eased and the small spring in the cocking links was changed as it had broken.

    What was quite interesting to me was that the "bump" on the trigger was wearing, along the lines of the "tuned trigger" that I put on Danny's site. I decided not to touch that yet as the trigger was not too bad.
    When I plinked again, I then thought that the pull was too heavy and too long. I have tried softer springs in the past and have cut a few coils off some. I found one I had cut down a bit and fitted that then took up some adjustment with the adjusting screw in the trigger. This resulted in a very short pull and seemed to "speed" things up.

    Now I may be wrong with this---and a lot of it is based on feel and I suppose some of it is subjective. I feel that a longer pull is more likely to make you pull your shot as the more your finger travels, the more movement you are likely to get in your arm. I have bad arms and have to shoot two handed as as soon as I start to take tension up in the trigger, my arm hurts and I have a tendency to pull a shot to the right.

    A quick digression on a Milbro Cougar, adjusting the trigger screw reduces the engagement in the 2 sears, but increases the length of pull, which i why i came up with the wedge insert idea that is also up on Danny's site.
    On a Scorpion i adjust the screw up so there is virtually no take up in the trigger.

    But back to Webleys. I think with their firing cycle and short sight line, a longer pull is more likely to make you pull the gun down or right (if you are right handed) . Your own thoughts are appreciated, but for me, a very short single pull is the best.

    I am still hoping one of the engineers will do a one piece trigger for a Senior , a bit like a Bsa Cadet one, so it travels through an arc and does not have to try and pull the sear vertically.
    Cooler than Mace Windu with a FRO, walking into Members Only and saying "Bitches, be cool"

  2. #2
    Join Date
    Jan 2012
    Location
    Knoxville Tennessee USA
    Posts
    435
    I have a Hurricane that was used as a police trainer in California, and tuned by their pistolsmith. The trigger sear bump is shortened, giving a very nice short pull, BUT this renders the safety completely ineffective! Love shooting it but for liability reasons would be afraid to sell it! (He later decided the shorter Tempest was more representative of their service pistols; they still use them.)

    Your comments on the effects of the longer pull are true for me. I have smallish hands and prefer the original narrow trigger blade, as it's easier for me to pull straight back. I tend to push the later wider blade (or an accessory "shoe") sideways.

    Although the stock grips fit me well, grip panels which wrap around the front of the frame like these old Beeman ones, move the fingers forward and also aid a straight-back pull.

    Last edited by MDriskill; 16-07-2024 at 01:24 PM.

  3. #3
    Join Date
    May 2017
    Location
    maldon
    Posts
    185

    I tried to address the problems I had with the Tempest with this one, trigger has the tune and the washers either side to stop the wobble. Narrow grips help achieve a straighter pull on the trigger and much better to shoot left handed without the safety.

  4. #4
    ggggr's Avatar
    ggggr is offline part time super hero and seeker of justice
    Join Date
    May 2008
    Location
    Flintshire Ch6 sort of near bagillt
    Posts
    2,384
    Quote Originally Posted by archer24 View Post

    I tried to address the problems I had with the Tempest with this one, trigger has the tune and the washers either side to stop the wobble. Narrow grips help achieve a straighter pull on the trigger and much better to shoot left handed without the safety.
    Someone I know was struggling for a couple of years trying various things with a Hurricane and a Tempest, until he remembered that I say I often try Webley pistol without grips when I have tinkered. He left the grips off and has 2 accurate Webley pistols.

    I have left the safety off and fitted some rough, home made ambi grips to a Tempest, mainly for lefties to try.


    OH--MDriskill------I have tried the wider triggers, even rounding and blending in the right side-----and like you, I prefer the narrow blade.
    Cooler than Mace Windu with a FRO, walking into Members Only and saying "Bitches, be cool"

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •