scope problem

[rapidresponse1]

turrets my up and down are the opposit way around if i want to go up i have to go down ,my left is the same if i want to left i have to go right,and now trying to bring the scope down to get it on target i run out of clicks i hope this makes sense and advice appreciated

[jjjjjj]

turrets my up and down are the opposit way around if i want to go up i have to go down ,my left is the same if i want to left i have to go right,and now trying to bring the scope down to get it on target i run out of clicks i hope this makes sense and advice appreciated

I had a Sope that was like that once, I can not remember what make it was, So to get it to shoot lower you will have to shim the bottom of the front scope mount, I use black electrical tape a couple of layers should be enough to bring it down.

[Neil54]

Have you got it the right way round? Only joking.

Some German scopes operate that way.

[rapidresponse1]

never had a problem like this before with any scope i will try shimmimg it tomorrow

[angrybear]

Clockwise should be down & left, anti-clockwise up & right, as far as I know that's universal to every scope.

What scope/rifle, is it new ? if so take it back if used contact the seller ask them, if a pcp is it fully charged

[rapidresponse1]

niko sterling mountmaster it come on a rifle i bought

[laverdabru]

niko sterling mountmaster it come on a rifle i bought

Had a similar issue with a Mountmaster years back. First one arrived damaged, took a lot of arguments to get it replaced. When it eventually was, the new one behaved like yours. Think I chucked it in a cupboard, probably still there. Funnily enough, had Mountmasters on some s/hand rifles I've bought, & they've been fine.
Can't remember the supplier.

[Jacklurcher]

turrets my up and down are the opposit way around if i want to go up i have to go down ,my left is the same if i want to left i have to go right,and now trying to bring the scope down to get it on target i run out of clicks i hope this makes sense and advice appreciated

Apologies if this sounds really obvious/daft, but you are using the arrows on the turrets to shift the point of impact of the pellet, not the point of aim of the scope?

[rapidresponse1]

yes thats what im doing thanks

[rapidresponse1]

give up on this scope

[rapidresponse1]

found a interesting thread on you tube that might solve this problem ,but far to windy at the moment to try it out

[rapidresponse1]

well a mild day today got my scope all sorted i was about to bin it thanks you tube

[averageplinker]

What was the solution?

[laverdabru]

What was the solution?

+1.

Bru

[rapidresponse1]

having turret tops remooved and changed around i did not do it my mate did