you could fill the holes with black wax
Hi all.
I've recently purchased a SFS HW999s Imp and I was just wondering what the best method would be to plug up the 2 holes where the open sites used to be. I was thinking of just buying some small black screws to plug up the holes and was just wondering where the best place would be to buy a couple that would fit. Also, I personally think that brass screws would look good, but again, where would you buy them from?
Any suggestions will be greatly appreciated lads,
John![]()
you could fill the holes with black wax
LSD made some with a 3d printer https://www.facebook.com/15864586015...6291792584046/
melted black crayon. Dripped in.
I use the little black plastic caps that cover the knots in the elastic which hold the scope covers together.
They are FREE![]()
Founder & ex secretary of Rivington Riflemen.
www.rivington-riflemen.uk
You could go for black grub screws, either slotted or hex head as you prefer. Not sure on size but could check mine later if it helps and give a supplier link.
I used black Milliput two part epoxy putty.
Put it in and smooth over the top.
It dries hard.
Arthur
I wish I was in the land of cotton.
I was going to suggest the endcap of a black ballpoint pen
![]()
Torn between the LSD cap, & some brass rod as a bit of bling on mine
Not done it myself yet, but when I do I’m going to try this stuff
https://www.amazon.co.uk/Sugru-Mould.../dp/B01BFE0KNQ
Thanks