Ok guys - My Lov 21 arrived yesterday. First impressions - it's pretty basic, lot of plastic but it functions ok. I tried it clamped in a workmate at 10m, the only wadcutter pellets on hand were Hobby. Three consecutive 5 shot groups c - c were 28mm, 21mm, 33mm. The holes showed evidence of a little pellet yawing, although I didn't run any through the crony there was plenty of power to cut clean holes.


So, the workmate isn't too solid, it was outside and a bit windy and not tried a selection of pellets so was quite pleased with the result. I did try my Walther CP2 at the same time and groups were a bit sloppy at around 10mm.


Planned work when time permits will be, improve the sights, trigger, weight and balance, palm shelf, smooth out the rough edges and take it from there. Some work for the 3d printer I think.