-
Problems, Problems
Well folks, yesterday afternoon I took a ride over to BBS member, steveo's house in Tamworth and picked this up which Steve kindly donated to the cause --- thankyou once again Steve. :-
image.jpg
Now here's the slight problem, I incorrectly thought that the HW80 had the plug joint 6mm back from the breech face like a HW35. :-
image.jpg
But it doesn't, the HW80 breech joint is in line with the breech face. :-
image.jpg
This means the breech plug diameter on the HW80 is 30mm right up to the breech face, so if I set the 32mm OD Mercury tube back from the breech face to allow for welding I'll have a step down to the 30mm plug which isn't ideal.
The answer is to fill the top step with weld and then hand finish the top breech face to correct things, which is a bit of a pain --- I won't bother with the bottom breech face too much as nobody will see it once the action's in the stock.
On the up side though --- my ally trigger didn't turn out too bad. :-
image.jpg
image.jpg
All the best Mick
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules