Hi folks,
I don't have a great deal of experience with these (read none!), and I would like to remove the rigger group from my Single / Master.
I could just take a punt and remove what would appear to be the correct screws, but I thought it best to ask for advice on how to proceed.

If anyone can give me some pointers, I would greatly appreciate it.

The reason for my question is that I purchased a Single which I couldn't get to work (enormous gas leak from everywhere, barrel, trigger... it was massive!).
Mark fixed me up with a new/old stock valve (and I am eternally, and greatly appreciative for that Mark!).

Anyhow... the new valve reduced the leak, but it still leaked out of the trigger area. First pull of the trigger expended ALL of the gas in the cylinder.
So... I managed to get another Hammerli (a Master in much better condition!), and I now need to scrap the previous Single (Australian license regulations).
So I want to take whatever parts I can salvage from the Single, for future use if needs be.

Hope that makes sense!

Regards folks,
Mike