Hi everyone,

I'm having some difficulty with a Kral Knight, the power is 8ftlb even with the power adjuster at max, its 6ft when at lowest. So I've been speaking with bagnallandkirkwood whom I have to say have been brilliant, the rear action has two pins holding the hammer adjuster in place.

I've managed to remove the top one but the other pin at the bottom is a different type of tamper proof, bagnallandkirkwood have said that no-ones been into one of these types of anti tamper, to their knowledge.

They said, I need to sleeve a pillar drill (to protect the internal thread) and drill out the locking pin and use an Allen key to turn out the residual steel locking pin.

I unfortunately don't have a pillar drill, but just wondering if anyone local in Devon could kindly help me remove this locking pin, so I can at least get the gun up to 10ftlb.

It's been tampered with before, as some of the screws we almost burred so badly that's it's been difficult to sort. I'm nearly there but without a pillar drill I'm a bit stuffed. I didn't want to buy a pillar drill, as they are quite expensive and wouldn't have much use for one other than this job and room is a premium as it is.

Any assistance in removing the locking pin would be most appreciated, I'm happy to pay for time and help and can travel daytime to most places in Devon.

Many thanks.