Hi Chaps

I know this has been discussed before but...

I'm bored at home with a fluey bug thing so I decided to have a tinker...

HW trigger cage drilled to 3mm on piller drill to accommodate larger diameter trigger pin.

3mm drill bit section at 10.1mm long cut off with a mini dremel wizz wheel to make a trigger blade pivot pin.

"Forbidden screw" removed completely from lower sear as no longer required. I've not seen this mentioned before.

Trigger tension screw cut down to less than half its original length.

front tab bent forward to give maximum forward position to TX200 trigger blade.

Both grubs wound well back on blade then 1st stage dialed in so trigger just lets off then 2nd stage dialed in and first and second stage tweeked to a perfect breaking-glass let-off.


Bingo. Took an hour and was very satisfying as I now have a lovely trigger reach on my MK2 HW77 in original stock.

Hope this was of interest to some.

Cheers
Matty