-
scorpion pistol piston head and parts
Hi,
I've finally got around to stripping my scorpion pistol. However, i noticed when i removed the piston the piston head/waster etc came apart from the piston (withe bar)
I've read the sticky on the stripdown (above) but i can't work it out. There is a bar from the piston head, how does this fit back into the piston??
I'm also going to order a new spring and a piston washer. The part directly behind the piston head fell to pieces when i removed it!
Where is the best place to order Knibbs or chambers? I've never ordered from either of these?
Cheers.
-
scorpion pistol
Hi Andy
The bar that you mention is part of the washer retainer and is held in the piston by a small round wire circlip. The part you said fell apart was the buffer. If you send the piston and the washer retainer to Chambers they will supply a new buffer and washer and assemble it for you.
Hope this helps
ATB
Bernie
-
Hi Bernie
Thanks for that. Good info, I'll look into it tomorrow.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules