Unfortunately not, the HW45 has a 13mm dovetail rail.
Hi There,
Looking for help with above,scope has a 9mm > 11mm
mount rail but it does not seem to sit parallel with barrel?
Does the hw45 have a 11mm dovetail.
Any help with above would be greatly appreciated.
Jimboman
Unfortunately not, the HW45 has a 13mm dovetail rail.
UBC Resident Cowboy
St Paul of 55
Been there, bought it, tried it, sold it
Thanks Paul,
Back to the drawing board and open sights then.
Regards,
Jimboman.
Don't give up, I believe that BSA make mounts that will fit 11-13mm rails. Check out Uttings for these I think.
ATB
UBC Resident Cowboy
St Paul of 55
Been there, bought it, tried it, sold it
Hi Jimboman,I recently put a Hawke RD25 AGSR 9-11 mm on my HW and the mounts that came with it fit nicely,and so does the Hawke Sport dot.
pic...http://i158.photobucket.com/albums/t98/kp54/hawke.jpg
pic...http://i158.photobucket.com/albums/t98/kp54/hawke2.jpg
pic...http://i158.photobucket.com/albums/t98/kp54/hawke3.jpg
hope this helps......
Keith
Last edited by Porky; 17-02-2010 at 01:58 PM.
Hi Guys,
Thanks for your help with above I'm sure i will get
round it one way or another,
Thanks again,
Jimboman.
I have the BSA mounts (in 30mm and 25mm) that are a good fit, also have a pair of "Hawke Match Mounts" which seem to fit well when the dovetail gripping "claw" is turned upside down to the wider position.
“We are too much accustomed to attribute to a single cause that which is the product of several, and the majority of our controversies come from that.” - Marcus Aurelius
Thanks for the info Adam,
RD30 mounts are integral to the scope.
Seen some Bisley mount raisers that might
help the situation.
Thanks again,
Regards,
Jimboman