Automatic Target Project

[Cones]

Just a quick bump for this thread.

I have just bought some parts to start looking at this project again.

2 DFrobot Mega boards
2 DFrobot Mega I/O shields ver1.1 with Xbee sockets
2 Xbee Radio units
1 Serial LCD Display 16x2

My progress so far with the code, is I can now send information from the master to the slave unit. I can send information to the LCD. I can drive the servos to fixed positions on the slave unit.

I now need...

1.) A proper menu system
2.) Up / Down menu and a start push buttons
3.) Several mode selections in the slave unit for the different sequences
4.) Timing software in the slave unit

In use the idea will be to select the mode on the LCD.

Rapid Fire 8 Sec
Rapid Fire 6 Sec
Rapid Fire 4 Sec
All targets To Front

Then pressing start sends the mode and go signal to the slave which will the run the servos.

Thanks

Mark