Quote Originally Posted by Airsporter1st View Post
I definitely think you should stick with the leather washer, but I'm wondering whether you perhaps undersized the other one. Being cup shaped its not normally necessary to size them as you would a polymer seal, just a matter of squeezing down on the OD to get it in.

Have you tried firing a few times with the tap open? that's what I usually do to make the seal conform to the cylinder wall.

Hi paul, yes i fired it a few times to try and squash the seal aginst the wall if you like, but if its a case of shooting quite a few pellets and the power may go up, then i will persevier. I just expected it to be maybe in the 6-7 ftlbs mark and pellets sticking in the wood at that range so its a little strange??

Ill try different pellets and see what happens. I may have a little trouble getting a reading from my combro, so may have to wait till sat to go to my club and use there scan if possible.

Has yours got the double spring or am i gonna be under power with this set up.

Thanks
Daniel