Sounds like the filler valve has got some dirt stuck in it, preventing it from closing.
You will need to get the gun serviced, or if you have the tools, remove the filler vale and clean it out yourself.
Hi hopefully someone can point me in the right direction...
I was filling my Ultra today and i got it up to 230 bar, shut the main valve off opened the bleed valve on the bottle and it just emptied the gun of air. I tried with the gun cocked and un-cocked but it still leaked out. i tried removing the fill probe after most of the air was gone and the remaining air leaked out of the fill valve. does anyone have any experience of this happening and if so was it an easyish fix or did you have to send it for repair? the gun is second hand so out of warranty.
thanks
Sounds like the filler valve has got some dirt stuck in it, preventing it from closing.
You will need to get the gun serviced, or if you have the tools, remove the filler vale and clean it out yourself.
https://m.youtube.com/watch?v=P0mi85-t_BM
Here you go, check this out....
HuMa regulated S200 .22...
Artemis PP800 .177...
Weihrauch HW45 .177
Before you strip the gun down, connect your air bottle to the gun & start to fill it by giving it a quick, short sharp blast, it might dislodge any crap that is stuck on the fill valve face.
If you are filling with a pump, forget what I have just said!
Thanks for the replys I took the fill valve out and there was a small piece of washer off of the fill probe stuck in there. After putting it back together I can fill to about 100 bar but then it starts leaking out, I guess this could be because of the knick out of the fill probe washer so I'll get a replacement and hopefully that will sort it out...
I think 230 bar is the recommended pressure if its regulated !