Tac, is it just ROA nipples you get, or are you able to order nipples for the Uberti 1858?
I'm afraid. I went to another local precision engineering company in the hope of getting what, to me, is a reasonable pricing in replicating the ROA cylinder axis pin.
A minimum of TEN gets me an initial unit cost of £50 plus VAT. If, like me, you are mathematically challenged and have to use a calculator, that works out at £60.00 before I add my meagre 10% profit for my trouble, and mailing it out at around £2.50 or so.
So, sorry, guys, you'll have to go ahead with your own arrangements.
ROA nipples, on the other claw, are still a go-er, at £18 a set of six including mail - just awaiting any more orders to add to the few I have already gotten to make it worth while in the shipping department.
tac
Last edited by tacfoley; 01-03-2016 at 04:14 PM.
Tac, is it just ROA nipples you get, or are you able to order nipples for the Uberti 1858?
See any here?
Nipple - Ampco - 6x.75mm - # 11 Cap
Fit Old Italian Revolver - 1 per Pack
Manufactured by Treso
Nipples - Revolver - 6x .75mm - #11 Cap
For Pietta Revolvers - 3 per Pack
Manufactured by Traditions
Nipples - Stainless Steel - 6x .75mm - #11 Cap
For Most Revolvers - 6 per Pack
Manufactured by Uncle Mike/Butler Creek
tac
Last edited by tacfoley; 29-02-2016 at 08:36 PM.
I would be interested in a set of nipples for my ROA, where do i send my 20 english pounds to ?
Kindest regards
Unfortunately not. As far as I can tell they need to be either 5.5x.9 pistol, or 12-28tpi. Cheers anyway.
No Mr here, Sir. Just tac.
1. You are added to the list.
2. I gettem.
3. I post here that I've gottem.
4. Then you PM me to get my address here in UK, and, of course, your own, and I send the bits to you at the same time as you send your cheque to me.
Always worked just fine so far.
I have wrenches for the ROA, too. Details via PM.
Thanks.
tac
Since my dealer/source is in PNW, I got a very fast resplone -
Hello Terry,
We measured a nipple in one of our Uberti ’58 revolvers and to the best of our measurements, the nipple is .215 diameter x 1.0 metric.
We do not stock replacement nipples for Uberti handguns and it would require us ordering them.
Awaiting your reply…
I reckon that by the time they've ordered them in they will prolly cost the same as getting them here.
Anyhow, I'm closing the 'shop' on Friday, Guys - order by then or go without
tac
Cheers Tac.
As far as I can tell from online research they are exactly the same thread.
ETA: just read your reply. No worries, cheers anyway.
Here's some if your stuck:
https://www.peterdyson.co.uk/acatalog/NIPPLES.html
Hi tac, can I get 6 nipples for the roa from you please, pm with payment details
Ps a wrench too cheers
Last edited by WarrenC; 05-03-2016 at 03:59 PM.