HW100 issues

[krisko]

The cylinder is just a source of air, if it is screwed in all the way in, not related to poi issue leaky cylinder or not.


If any issues with hw100, the 2 easiest to swap o ring are on and inside the brass nipple. Replace both. Was it 6-8-10mm hex or so socket driver what you need, If the internal o ring fails, the reg stays fully open exposing the knock open valve to full cylinder pressure. Resulting in low power, poi drop

It is very easy to check if it is a reg, fill the cylinder only to the top of yellow section under the green section on the gauge and re check power. Fill again full recheck power. If poi moves a lot you know it is the reg.

Does your gun group at all, not just spraying pellets? ��

Always shoot few pellets, some guns regs leak so right after filling you need a dry fire or 2 or to cycle the reg, empty the full prechamber.