Everything has a tolerance!
I have quite a few metric O rings that are identified on the individual packets as having a 1.6 mm cross section, however when i measure them they are 1.5 mm cross section. Is this usual as it has me confused, many thanks for any replies.
Kindest regards
Barrel
IF I WALKED ON WATER PEOPLE WOULD SAY I COULD NOT SWIM !
Everything has a tolerance!
Plinkerer and Tinkerer
As above but there will always be a degree of compression when you measure with calipers or a micrometer unless it's a solid object?
Also depends on the quality/accuracy of your measuring device
Thanks for the information guys, really helpful.
Kindest regards
Barrel
IF I WALKED ON WATER PEOPLE WOULD SAY I COULD NOT SWIM !