Quote Originally Posted by gc93 View Post
had the same kind of problem. the action block when nipped up didn't sit right on the bottom of the stock cut-out, there was a slight gap over three parts of the block action and block action cut-out in the stock. this caused tension on the cylinder to stock fit and front barrel band/ scope rail to stock fixing, this caused the point of aim to be all over the place / wander about as pressure altered through the shot string I fixed with a few things. by making a shim out of a bit of plastic, used araldite between stock and the plastic shim to level the gap and nipped the action back up, did a £20 note test between the cylinder and stock found the note just bind here and there. found a bit of pipe slightly less than cylinder o/d wrapped sand paper around it and sanded the cylinder cut out a little till the £20 note slid up and down the cylinder freely. SORTED. hope it helps ...
Thanks very much.i knew someone must of had this experience before.ill get on it today and see what happens.
I messaged craft man vit about it and it seemed as if he knew but didnt want to admit it was the stock.his reply was basically pretending not to know what I was talking about because of his english but I've messaged him before and had no problem communicating.
He just said he couldn't help me and that was that.