I was told air arms 410 tube will fit
Getting hold of one of these a nightmare.
Havnt had a response from Brockock and no one else seem to be able to supply one.
Would think some other model would fit but in dark on this.
Any ideas gents?
snarepeg.
I was told air arms 410 tube will fit
Last edited by wild dogman; 05-06-2020 at 05:54 PM.
AirArms 400/500 tubes are M29x1.25 threads. Carbines is 300mm long, standard 400mm. Measure the ends of yours to see if similar.
Thanks gents.
Have somewhere an end from a 410 tube, and that's the problem, somewhere.
Have spent an hour discovering what I forgot I had but not that bit.
The enigma is 32 mm diameter.
snarepeg.
OD thanks.
snarepeg.
I removed one a while ago as it became belled around one end, probably could cut it back and re use it, I think I got my replacement from Silco, but it was a couple of years ago.....
You might find that the inside diameter is the same as the AA --im sure I read on here that somebody had used a AA cylinder on one look here http://www.airgunbbs.com/showthread....brocock+enigma
Last edited by ZAKDINGEL; 06-06-2020 at 01:16 PM.
Have just tried a AA cylinder, threads the same, depth the same.
About 1/2 inch in length different (carbine) but as it's a free floating barrel don't see a problem.
Will order one to morrow 👍
snarepeg.