Basically, yes. It can sometimes help to tap it one way a bit then tap it back then tap it forward again etc. A squirt of a lubricant on the piston body from both ends can help . Removing the tap can help this but if you are concerned, stay with lubrication from the cylinder end.Originally Posted by Joseyw
Yes gave it a go
Muzzle on carpet, hand on trigger block (but was only hand tight ? ) unscrewed barrel, was easier than expected but the spring length when removed was only 230mm long perhaps this was why and I got lucky!
Just got to remove piston now, is this by gently tapping piston down through the cocking lever slot until there’s something to get hold of?
Cheers.
It will come out....
Cheers, Phil
Reply With Quote