Cleaning rod with no attachment from muzzle end and a piece of 4.5/5.5 rod from breech. Knitting needles are good source. Sandwich between them
Having a nightmare trying to put one in.
Tried it more ways than the Karma Sutra and got older.
Any tips Gents.
snarepeg.
Cleaning rod with no attachment from muzzle end and a piece of 4.5/5.5 rod from breech. Knitting needles are good source. Sandwich between them
Have resealed it, and been trying to fit just with face plate, tried with pellet pushed past seal groove, various types of tools etc but no joy.
snarepeg.
remove air cylinder, remove barrel, split the 2 halves, remove breech block. use cleaning pellet pushed up near groove in block.
fit new oring. remove cleaning pellet. fit new 12 x 1 oring to breech block. connect both halves. refit barrel (check serial number on left). refit cylinder.
this is the quickest way to do it.
Sorted.
It was easy really, once I took the old seal outI had probed with tool but couldnt feel one and as it was blowing that bad assumed it was out.
Anyway it's up and running nice.
snarepeg.
Your not on your own, bud. I'm the same. I keep being told 'I'm at a funny age.'