Had many a HW Barrel chopped and no problem in the accurate stakes at all as long as the job is done properly . In some cases made the rifle even better with a wider range of pellets. Mach 1.5
I’ve got a HW95 in .25 that has a 410mm open sight barrel that has been screw, I think that the rifle is slightly long with a silencer attached and I am considering having it shortened a re screw cut, the dilemma is that I will lose the choke, has anyone lost the choke on a .25 HW barrel and what were the repercussions accuracy wise, if any ?
Had many a HW Barrel chopped and no problem in the accurate stakes at all as long as the job is done properly . In some cases made the rifle even better with a wider range of pellets. Mach 1.5
Take the mod off, a springer doesn't need one and get a steel overfit cocking aid/barrel weight,air stripper made instead of putting money into a barrel chop and losing the choke.
I saw a 95 on an American YouTube vid. It had a cocking aid that came back down the barrel just being attached by the 1/2" unf thread. To me it looked way better than how we get them in the uk.
Plinkerer and Tinkerer
You could fit a backdraft style moderator.
This has the screw thread halfway inside and slips over the barrel.
Repariere nicht, was nicht kaputtist.