It's probably the green O ring on the brass nipple where the cylinder screws in.
Bagnall and Kirkwood should do seal kits for these.
Hi,
If I unscrew my cylinder and fill it there is no leak but when I screw it back on to the rifle it leaks when fully hand tight. If I slacken off it stops but fhen the cylinger isn’t fully screwed hand tight!
Any thoughts?
Many thanks
T
It's probably the green O ring on the brass nipple where the cylinder screws in.
Bagnall and Kirkwood should do seal kits for these.
HW100 Tuning is also a very good place for spare parts and advice.
To seal the inlet valve, I prefer the black seals. I find the red polyurethane ones are a tiny bit small and my rifle was forever leaking. They're good for the fill port though.
If you change it make sure you only use a wood or plastic cocktail stick to prise it off the brass nipple as it's easily scratched if you use a metal pick.
Its part number 2665, available from my work at a £1 each.