no need to drill the rekord cage ...all that was needed was a piece of 3mm tube with a 2mm id .....so you can go back to a rekord blade done a couple
Hi Chaps
I know this has been discussed before but...
I'm bored at home with a fluey bug thing so I decided to have a tinker...
HW trigger cage drilled to 3mm on piller drill to accommodate larger diameter trigger pin.
3mm drill bit section at 10.1mm long cut off with a mini dremel wizz wheel to make a trigger blade pivot pin.
"Forbidden screw" removed completely from lower sear as no longer required. I've not seen this mentioned before.
Trigger tension screw cut down to less than half its original length.
front tab bent forward to give maximum forward position to TX200 trigger blade.
Both grubs wound well back on blade then 1st stage dialed in so trigger just lets off then 2nd stage dialed in and first and second stage tweeked to a perfect breaking-glass let-off.
Bingo. Took an hour and was very satisfying as I now have a lovely trigger reach on my MK2 HW77 in original stock.
Hope this was of interest to some.
Cheers
Matty
Opportunity is missed by most people, because it is dressed in overalls and looks like work.
no need to drill the rekord cage ...all that was needed was a piece of 3mm tube with a 2mm id .....so you can go back to a rekord blade done a couple
them there springer's are soooooo addictive
Hi Mate
Some of us don't have access to such tiny tubes nor could I make one...
As many of you know my usual choice of tool is either a hammer, a power file or a recip saw
But... I would guess it would be legit to drill a Rekord trigger blade hole out from 2mm to 3mm if one required a retrofit...
It's all great fun anyway
Matty
Last edited by MattyBoy; 07-02-2024 at 02:04 PM.
Opportunity is missed by most people, because it is dressed in overalls and looks like work.
Nicely done, I have used the tx blade in an Lgv to good effect.
Can the AA trigger blades be bought separately?
Too many airguns!
them there springer's are soooooo addictive
Do you remove the forbidden screw Joffy?
I have some 7mm aluminium plate so my next tinkering will be to hand-fashion a Record /CD hybrid trigger Blade with adjuster grub screws.
I made one before but inserted the hardened pins from a spare HW blade rather than drilling and tapping for M3 grubs.
Matty 😁
Opportunity is missed by most people, because it is dressed in overalls and looks like work.
Luftgewehr100 on here used to make and sell the on the bay I bought 2 but the tx blade works fine
them there springer's are soooooo addictive