Yeah! And then some! Difference is dramatic to say the least. On the trigger assy..same deal as the MX-10. For some reason it lacks adjustment which is as simple to implement that you drill and tap a M3 hole on the sear and that´s it. Then again, the one shaping that trigger guard? Was that specific turk on drugs?!? HELLO!
That said.
Goes from "a joke" to about "match quality" in one move. Aselkon.. what can i say?
So yeah. Now i could actually use the thing.
Uhu. The probe on these things are spring loaded. All good and a smart move, however as it turns out the probe BODY will actually obscure the barrel transfer port, and that to the amount of like 40% total or so!
For now.. i just tossed that thing on the lathe and done deal. HOWEVER.. i experienced a puff of air to my head through the mag as i shot the thing. Taking the micrometer to the probe it showed a mere 5.5mm.
So brazed some material to that there and turned unison on the lathe for a cool 5,75mm... way better but still not kosher. So believe i´ll do as i did on the MX-10 and cut the front end of that probe off and replace with a thicker one... threaded M4 and take it from there. In turn sporting a 1.5mm probe end...
Ah! The solution to all ills!
Nah. But at first i took the calipers to the stock setup hoping i could get away with just putting a "spacer" on the plenum and done deal. No dice. That´d render like maybe 20cc´s more before running into dead stop at the suppressor.
So eff it. Time for a stand alone plenum in short, cause by now we KNOW these puffs will perform just handed the hardware. Indeed...
Then.. this.
You´ve seen me pull this stunt a No of time by now, and the reason why is that it works so well it´s to laugh at. Yep. First up an all PEEK seal and in turn a 2mm spindle. Mind you... the capacity added does NOT have to be forward higher power. It can JUST as well be used to cut down on cocking effort wish be.
Yeah. So right now.. at a stand still. Want to hand the Loctite involved ample time to cure and what not. Entry point on the stock "plenum" i drilled and tapped for 1/2"-28UNEF.
That MX-10.. sorts of stonewalled already at 65J before them trix thrown at it.
This one made 75, i guess mainly due the EVER so slightly larger volume between the reg and the valve. Where this´ll end up we´ll see tomorrow..
Reply With Quote