Originally Posted by
look no hands
Like I said before, I use Welsh Willy spring kits as they are ready to drop in, being a shorter spring in the kit helps getting the trigger block back on easier, I have a swivel vice and on reassembly I put the flat part of the trigger block in the vice and then push the cylinder onto the trigger block and then twist onto the thread, make sure the bolt that holds the threaded cup to the block is tight because if that loosens then its a bugger to get back off, as it will spin, getting the trigger block off will normally need a sharp hit with a rubber mallet on the flat part (it twists off anticlockwise by the way), once you have the block twisting, I sit on the floor with a bundle of old wrags between my thighs and place the block inches wrags and then the cylinder vertically until the block come off, there will be a lot of spring pressure, so be prepared.