Thanks mate, I'll do that in the morning.
Thanks mate, I'll do that in the morning.
Pis sent, mate.
Damn I was hoping for a nice bit of Apple pie and cream, never mind ay, hope you get the answers you need AM.
You'll Shoot your eye out Kid
Currently looking for an SMK/BAM B4-4 Rear sight or help modifying current one.
I think TonyL was thinking it was a 77 hence he mentioned 25mm. 80's are 30mm piston unless you have a venom lazaglide which is then a 25mm piston. Mach 1.5
well, it's not pretty...
I think that barrel is probably toast, but if the breach end cleans up fine, you can possibly chop a couple of (rusty) inches off the muzzle and save it... ?
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
Thanks JB. However I don't have access a lathe. It's going to be a very rudimentary de rust and phosphoric coating of all salvageable parts. Machine work isn't something I can do.
I'll try to smarten the stock. Strip/derust and bumslide all moving parts that require it. I do have a piston extension here from tinners. I'll get a guide and washer from him and just have to source a new barrel. Hopefully in 20 cal
As in make a Carbine I'm guessing? That would make a cool custom with the right stock.
You'll Shoot your eye out Kid
Currently looking for an SMK/BAM B4-4 Rear sight or help modifying current one.
before I had a lathe I choped barrels with a hacksaw, got them true by twizzling them with the muzzle held againt the side of a bench grinder spinning disc, and then crowned with a brass roundhead screw in a drill and some lapping compound. Took a bit longer, but the final accuracy result was perfectly good
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.