13mm mount or arrestor block?

[TonyL]

Hi nice people of the BBS.

Would anyone by chance have a 13mm dovetail mount (or mounts) in low flavour that are surplus to requirements? I have the Sportsmatch medium ones but these are a tad too tall for my purposes.

Or an arrestor block to fit the same, 13mm, dovetail.

It's for an older HW35 with the wider rail. Lots of stuff available for 11mm dovetails...

Thank you in advance.

I'll post in the Wanted section also.

[MattyBoy]

Pm sent Tony 👍

[TonyL]

Thank you, Matty. PM replied to.

[rapidresponse1]

hope you get sorted tony looked through my spares box sorry nothing mate

[TonyL]

Thanks for looking, Jeff.

No joy as yet.

However, if anyone has some 13mm mediums going for cheap money, they'd also fit the bill, as I could cut the rings off and file some material away. I didn't want to do that on my recently bought new ones.....

[capt hindsight]

What's the height Tony - marked A on the sportmatch diagram?

I definitely have some 13mm but not sure if they are low or medium.

[TonyL]

Thank you for the reply. I'll measure the ones I have and come back to you. But it'll be this evening / tomorrow, unless I find those dimensions online.

[TonyL]

Ah. Found it. Existing ones are the T06C, so 19mm. In a perfect world, for my uses, the A measurement would be about 16mm. But even at 19mm, this would be fine as I can modify them.

Thank you.

https://www.sportsmatch-uk.com/13mm-...t-arrestor-pin

[TonyL]

Ah....I've just seen the T035C mounts on that link that I've put up. They should do the trick if I can get some. They hadn't been on my radar previously as they are for 30mm tube scopes. Will check availability....

Looking quite pricey. May go for them but will wait and see if any pre-owned ones come up first.....

[TonyL]

What's the height Tony - marked A on the sportmatch diagram?

I definitely have some 13mm but not sure if they are low or medium.

Either would be fine methinks, sir, as I can modify if needs be. Talk later....