That's a great idea Mick.
I don't have any long roll pins but I do have 9mm brass rod.
Registered User
That's a great idea Mick.
I don't have any long roll pins but I do have 9mm brass rod.
Repariere nicht, was nicht kaputtist.
Registered User
I would be careful and double check the transfer port is bored straight and not dog legged before drilling out or it could cause you a headache bud.
Registered User
The transfer port is straight, angled from the centre of the compression chamber upwards towards the breech.
There is no dog leg in this one.
Thank you for your cautionary warning.
Repariere nicht, was nicht kaputtist.
Administrator
Originally Posted by Neil54
That's a great idea Mick.
I don't have any long roll pins but I do have 9mm brass rod.
I find that I have to fit roll pins on drill bits below a certain size in order to get some chucks to tighten onto them as well, Neil.
Registered User
You can buy long series drill bits on E--yThat's a great idea Mick.
I don't have any long roll pins but I do have 9mm brass rod.
.22 Venom Mach 1 (FAC) 6-25x56 Millett.
.22 Venom Mach 2 Thumbhole 6.5-20x40 Leupold EFR.
.22 Venom Mach 2 Sporter 4-12x40 Leupold.
.177 Venom Vantage 4-16x50.
.177 Venom Daystate 8-32x56 AGS.
.22 Venom Datstate 4-16x56 AGS.
.22 Webley Venom FX2000 6-18x40 Busnel Legend.
.177 Titan MPT by Steve Pope 6-24x40 Tasco.
.177 Pro-Sport 4-16x50.
.22 Webley FX2000 3-9x33 Leupold EFR.
.177 Logan Solo 4-16x50.
.22 HW90 (spring powered) 4-16x50
.22 Gamo Stutzen.
.177 Walther lever action.
Registered User
Yes I know. I wasn't sure if they would be long enough. Its just quicker if I make an adaptor. The adaptor can then be increased to whatever size I need.
Next time I needed the long drills I probably would not be able to find them.
Repariere nicht, was nicht kaputtist.
Posting Permissions
Reply With Quote