Opportunity is missed by most people, because it is dressed in overalls and looks like work.
Jon
what length spring and what coil count and wore thickness do you need?
I want ~ 3.2mm wire, around 21 - 21.4 OD
Coils and length is the experimentation - I want a few more coils, and a little more length, to get an overall softish but not too soft and unstable spring. I need to measure lenght, but obviously if I go a bit long it's easy enough to trim. #1 looked a good spec.
Last edited by Shed tuner; 02-12-2013 at 11:11 PM.
Hi all
Just thought I would add this to the mix.
One of the guys I shoot against is running a titan No7 in his tx with good results.
I shot it & it felt very fast but a little harsh for my liking, all other internal details he seems reluctant to divulge.
Have any of you tried one before I waste my money.
Regards Jon
I tried the 9 in my set up & it made power very easily, so much so I had to cut a few coils off.
With minimal top hat the spring has only 5mm preload which gives me 11.2-11.3 f/lb.( also gets a bit stiff to cock towards the end but not excessive )
The number 10 had 47mm preload to make 11.2f/lb
Jon
I use the No 9 and the Mk2 in my guns depending on stroke, the No 9 is good and makes power easily but is a bit stiff to cock, I would like something in between ideally
Nick
I was a bit concerned that with so little preload that it would not keep the bounce in check, but it seems to shoot fine @ 25 yards, of to test it out to 55 this morning.
Jon.