READ PT1 AND 2.
BASIC strip for break barrel airguns.
Remove sights and put in a tin or box. This applies to all bits you remove. You can put them in pellet tins (stock screws,trigger bits,pivot pins etc). Undo stock screws and remove action from stock. Remove pin/screw from cocking arm and then slide it from barrel and cylinder. Just break barrel a little and depress barrel plunger with small block of wood and knock barrel pivot pin out,gently releasing pressure on block of wood so plunger and spring dont fly. Remove trigger bits and cylinder end cap and then you are ready for the cylinder. Place your cylinder on your big bit of wood,breech jaws down,then using your tube with a slot in, push down with your rigger glove on the tube to compress the mainspring and guide and push out the cylinder end pin. (helps if you put your gut over the hand you are pushing down with). Slowly release weight and the spring and guide should come up. If they dont, then keep the end of the cylinder pointed into a rag in a safe direction as sometimes the endplugs or guides are tight. You should now be able to slide the piston out and get to the piston washer. SPECIFIC GUNS COMING UP NEXT! It will be Diana22/23, webley junior,jaguar,ranger strip.