Just google it https://www.pipestock.com/hydraulic-...steel-tube?p=3 for example or e bay
Where does one purchase the 30mm steel tube from for a hw80 25mm conversion?
is hopeless
them there springer's are soooooo addictive
Just google it https://www.pipestock.com/hydraulic-...steel-tube?p=3 for example or e bay
Yep I found that site but don't need 3 metres
them there springer's are soooooo addictive
The problem you have is your required internal dimension is too close to what is known a ‘nominal bore’, in your case 1” nb. Any pipe/tube you find around that size will be just over 25mm ID, so you have no material left for a finish cut.
See *bay 221896041212 to see what I mean.
You may have more luck finding a tube more designed for structural uses than fluid transfer, race car cages, kart chassis etc.
I found some 30mm od 24mm id maybe get 0.5mm machined off it?
them there springer's are soooooo addictive
These are the tube specs for the tube that Bigtoe sent me to sleeve my 35 down --- no refinishing needed on ID or OD. :-
https://www.hublebas.co.uk/products/...1-c31776df7d90
Just make it a 24mm conversion instead - that's exactly what I did with my HW80
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.