AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
https://imgur.com/a/qLbDdzR
Bit of an unusual approach to attaching a comb to the pup but it works remarkably well , will replace with a new one at some stage
What isn't obvious is how I managed to keep it in place.
A small magnet is inlet into underside of comb so even if turned upside down the comb stays put
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
https://imgur.com/a/0VGCEbF
After 3 coats of oil
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
https://imgur.com/a/qc9E5Jc
still needs more oil
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
Would have been better looking if it was possible. The inlettting for the trigger connecting rods are quite deep and there is only 10-15mm of wood left wheer the rear stock bolt is. Doesn't afect me as I always shoot thum up . I need to address the inletting as it makes the action quite noisy, may add sound deadening to make it quieter.
Have a different trigger link idea that wold make thumbhole stock possible, will try it out if funds allow.
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
I built an aluminium TX 200, and made a stock from ally channel , it was very noisy , I quietened it down by injecting spray foam, it worked well , wrap the action in cling film to protect it .
As the hand grip was too far away from trigger and only option I could think of was to replace it ..... I thought I might as well have a go at making it a thumbhole
https://imgur.com/a/o3iy3bF
Pity about the screw and the hand grip is obviously too deep plus it needs a little more sanding and re-oiling amd still need to sort out the hinge.
All in all it's not too bad
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/