Take a washer out.
Mine run close from the factory, TX's and Prosports.
Close is not over so they can stay that way.
Hi I've just bought a second hand nearly newTX200HC and the gun has only shot about 100 pellets. As it's been sitting for a few years I've stripped it and serviced it following the recommend lube.
I tested it and it's not pellet fussy but it's very close to the legal 12ftlb limit. There are three washers on the bottom of the spring guide can I just remove these to reduce the power or would reducing the spring be better ? Any help much appreciated
Smile they said life could be worse,
I did and it was !!
Take a washer out.
Mine run close from the factory, TX's and Prosports.
Close is not over so they can stay that way.
"Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote!" -- Benjamin Franklin
if you have and JSB RS or express 13.43 / 14.3 grain, try it with them...
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
I've tried JSB express RS and want to get a couple of heavier express patterns; most of my PCP's are 177 so I havn't got a great selection of .22
The RS's are pellet on pellet in my Kral Empire x .22 at 30m and are my go to pellet for hunting, accurate, fast and very littls hold over at 40m.
Smile they said life could be worse,
I did and it was !!