As the title says.
the AirStream Reflex seems quite interesting as it stick out just 10cm.
I think it probably will
Daystate use LW barrels as well, so the barrel OD should be ok, you'll have to 'do the maths' on how far it reflexes back though.
I've a Daystate Airstream MK3 (I think) here in .177 & its very good.
The fact that Daystate and FX use Walther barrels is irrelevant I'm afraid.
Daystate rifles and FX Verminators both have shrouded barrels, so it's the diameter of the shroud that's important.
Graham, whilst it is possible to buy some FX guns with a sleeved LW barrel, the vast majority use the standard LW barrels (2 different sizes offered). The Verminator uses the standard barrel.
i think you can retro fit them i think you have to get an oring that is the right size to go over the barrel and prevent any air coming out. as others have said you may want to look at the sizes to make sure one would fit.
Verminators have shrouded barrels.
you'll be lucky if they did as my understanding is that they are caliber and Daystate model specific.
Daystate Mk4S, Mk4 moderator, MTC Viper, 4-16x50 scope. AA510s, TX mod, MTC Mamba, 4-16x50 scope, Yukon NVMT 4 Monocular with day scope adaptor. HW45 Silver Star. All .177. When there's a lynch mob in town, join 'em or hide but don't try reasoning with them
This is all much too messy for me,
Gentlemen, sort it out amongst yourselves.
[Ding Ding, round 1]
Daystate Airwolf MVT.22 40ft RUGER77/17hmr RUGER SR22
"DON'T EVER SHOOT A 17 HMR. What ever you thought you knew about 22 rim fires, and loved about them, will be lost forever. It's like dumping your wife for Miss America."
Hi, I believe the mk1 verminator (or gladiator - big brother) do not have shrouded barrels. The mk2 does though.
I own a gladiator and mk 1 verminator.
Early mk1 verminators did have a brass adapter to 1/2 inch UNC male for suppressors but my mk1 is circa 2011 and has a smooth-twist barrel (only partial rifling) and does not have the brass figment. What it does have is 2 inches of extra barrel length with a capping piece to cover the manufacturing marks from making the smooth twist, which is also directly threaded for 1/2 inch UNC male. I believe this is the same barrel that lurks inside the mk2 shroud.
When I bought it second hand I was concerned that the barrel looked wrong compared to a friends earlier mk1 so I contacted the fx importer and was told the above.
So early mk1s probably don't have enough barrel past the cylinder to accommodate an airstream but later ones I think do, which would be nice so as to offset the new longer barrel.
Personally I came on here to find a custom reflex moderator on a recommendation from someone at my local range...
I hope the above info helps.